2 # GENERIC -- Generic kernel configuration file for DragonFly/x86_64
4 # Check the LINT configuration file in sys/config, for an
5 # exhaustive list of options.
14 makeoptions DEBUG=-g #Build kernel with gdb(1) debug symbols
16 options INET #InterNETworking
17 options INET6 #IPv6 communications protocols
18 options HAMMER #Hammer Filesystem
19 options NULLFS #NULL filesystem
20 options FFS #Berkeley Fast Filesystem
21 options FFS_ROOT #FFS usable as root device [keep this!]
22 options SOFTUPDATES #Enable FFS soft updates support
23 options UFS_DIRHASH #Improve performance on big directories
24 options MFS #Memory Filesystem
25 options TMPFS #Temporary Filesystem
26 options MD_ROOT #MD is a potential root device
27 options NFS #Network Filesystem
28 options NFS_ROOT #NFS usable as root device, NFS required
29 options MSDOSFS #MSDOS Filesystem
30 options CD9660 #ISO 9660 Filesystem
31 options PROCFS #Process filesystem
32 options COMPAT_43 #Compatible with BSD 4.3 [KEEP THIS!]
33 options SCSI_DELAY=5000 #Delay (in ms) before probing SCSI
34 options DEVICE_POLLING # Support mixed interrupt-polling
35 # handling of network device drivers
36 options UCONSOLE #Allow users to grab the console
37 options KTRACE #ktrace(1) support
38 options SYSVSHM #SYSV-style shared memory
39 options SYSVMSG #SYSV-style message queues
40 options SYSVSEM #SYSV-style semaphores
41 options P1003_1B #Posix P1003_1B real-time extensions
42 options _KPOSIX_PRIORITY_SCHEDULING
43 options ICMP_BANDLIM #Rate limit bad replies
44 options KBD_INSTALL_CDEV # install a CDEV entry in /dev
45 options AHC_REG_PRETTY_PRINT # Print register bitfields in debug
46 # output. Adds ~128k to driver.
47 options AHD_REG_PRETTY_PRINT # Print register bitfields in debug
48 # output. Adds ~215k to driver.
50 # To make an SMP kernel both SMP and APIC_IO are usually
51 # specified. SMP boxes with severely broken BIOSes which
52 # boot fine for non-SMP builds *might* work in SMP mode
53 # if you define SMP and leave APIC_IO turned off.
55 #options SMP # Symmetric MultiProcessor Kernel
56 #options APIC_IO # Symmetric (APIC) I/O
58 # Debugging for Development
66 # Firmware assist module
67 device firmware # firmware assist module
69 # AHCI driver, this will override NATA for AHCI devices,
70 # both drivers may be included.
78 # NEW-ATA (NATA) and ATAPI devices
81 device natadisk # ATA disk drives
82 device natapicd # ATAPI CDROM drives
83 device natapifd # ATAPI floppy drives
84 device natapist # ATAPI tape drives
85 device natapicam # Emulate ATAPI devices as SCSI
86 device nataraid # support for ATA software RAID
88 device natausb # ATA-over-USB support
89 options ATA_STATIC_ID # Static device numbering
91 # LEGACY ATA and ATAPI devices
92 #device ata0 at isa? port IO_WD1 irq 14
93 #device ata1 at isa? port IO_WD2 irq 15
95 #device atadisk # ATA disk drives
96 #device atapicd # ATAPI CDROM drives
97 #device atapifd # ATAPI floppy drives
98 #device atapist # ATAPI tape drives
99 #device atapicam # Emulate ATAPI devices as SCSI via CAM
100 #options ATA_STATIC_ID #Static device numbering
103 device ahb # EISA AHA1742 family
104 device ahc # AHA2940 and onboard AIC7xxx devices
105 device ahd # AHA39320/29320 and onboard AIC79xx devices
106 device amd # AMD 53C974 (Tekram DC-390(T))
107 device isp # Qlogic family
108 device mpt # LSI-Logic MPT/Fusion
109 device ncr # NCR/Symbios Logic
110 device sym # NCR/Symbios Logic (newer chipsets)
111 options SYM_SETUP_LP_PROBE_MAP=0x40
112 # Allow ncr to attach legacy NCR devices when
113 # both sym and ncr are configured
121 device ncv # NCR 53C500
122 device nsp # Workbit Ninja SCSI-3
123 device stg # TMC 18C30/18C50
126 device scbus # SCSI bus (required)
127 device da # Direct Access (disks)
128 device sa # Sequential Access (tape etc)
130 device pass # Passthrough device (direct SCSI access)
131 device sg # Passthrough device (linux scsi generic)
133 # RAID controllers interfaced to the SCSI subsystem
134 device asr # DPT SmartRAID V, VI and Adaptec SCSI RAID
135 device dpt # DPT Smartcache - See LINT for options!
136 device iir # Intel Integrated RAID
137 device mly # Mylex AcceleRAID/eXtremeRAID
138 device ciss # Compaq SmartRAID 5* series
141 device aac # Adaptec FSA RAID, Dell PERC2/PERC3
142 #device aacp # SCSI passthrough for aac (requires CAM)
143 device ida # Compaq Smart RAID
144 device ips # IBM ServeRAID
145 device amr # AMI MegaRAID
146 device mlx # Mylex DAC960 family
147 device twe # 3ware Escalade 7000/8000's
148 device twa # 3ware Escalade 9000's
150 # atkbdc0 controls both the keyboard and the PS/2 mouse
151 device atkbdc0 at isa? port IO_KBD
152 device atkbd0 at atkbdc? irq 1 flags 0x1
153 device psm0 at atkbdc? irq 12
157 # kbdmux is the keyboard multiplexer
160 # splash screen/screen saver
163 # syscons is the default console driver, resembling an SCO console
164 device sc0 at isa? flags 0x100
165 options SC_PIXEL_MODE # add support for the raster text mode
167 device agp # support several AGP chipsets
169 # HW monitoring devices
170 device aps0 at isa? port 0x1600
171 device lm0 at isa? port 0x290
172 device it0 at isa? port 0x290
173 device it1 at isa? port 0xc00
174 device it2 at isa? port 0xd00
175 device it3 at isa? port 0x228
176 device wbsio0 at isa? port 0x2e
177 device wbsio1 at isa? port 0x4e
178 device lm#3 at wbsio?
180 # PCCARD (PCMCIA) support
186 device sio0 at isa? port IO_COM1 flags 0x10 irq 4
187 device sio1 at isa? port IO_COM2 irq 3
188 device sio2 at isa? disable port IO_COM3 irq 5
189 device sio3 at isa? disable port IO_COM4 irq 9
192 device ppc0 at isa? irq 7
193 device ppbus # Parallel port bus (required)
195 device plip # TCP/IP over parallel
196 device ppi # Parallel port interface device
197 #device vpo # Requires scbus and da
201 device de # DEC/Intel DC21x4x (``Tulip'')
202 device txp # 3Com 3cR990 (``Typhoon'')
203 device vx # 3Com 3c590, 3c595 (``Vortex'')
205 device em # Intel PRO/1000 adapter Gigabit Ethernet Card (``Wiseman'')
207 device ig_hal # Intel PRO/1000 hardware abstraction layer
209 # PCI Ethernet NICs that use the common MII bus controller code.
210 # NOTE: Be sure to keep the 'device miibus' line in order to use these NICs!
211 device miibus # MII bus support
212 device ae # Attansic/Atheros L2 Fast Ethernet
213 device age # Attansic/Atheros L1 Gigabit Ethernet
214 device alc # Atheros AR8131/AR8132
215 device ale # Atheros AR8121/AR8113/AR8114
216 device bce # Broadcom NetXtreme II Gigabit Ethernet
217 device bfe # Broadcom BCM440x 10/100 Ethernet
218 device dc # DEC/Intel 21143 and various workalikes
219 device et # Agere ET1310 10/100/1000 Ethernet
220 device fxp # Intel EtherExpress PRO/100B (82557, 82558)
221 device jme # JMicron Gigabit/Fast Ethernet
222 device pcn # AMD Am79C97x PCI 10/100 NICs
223 device rl # RealTek 8129/8139
224 device re # RealTek 8139C+/8169
225 device sf # Adaptec AIC-6915 (``Starfire'')
226 device sis # Silicon Integrated Systems SiS 900/SiS 7016
227 device sk # SysKonnect GEnesis, LinkSys EG1023, D-Link
228 device ste # Sundance ST201 (D-Link DFE-550TX)
229 device tl # Texas Instruments ThunderLAN
230 device tx # SMC EtherPower II (83c170 ``EPIC'')
231 device vge # VIA 612x GigE
232 device vr # VIA Rhine, Rhine II
233 device wb # Winbond W89C840F
234 device xl # 3Com 3c90x (``Boomerang'', ``Cyclone'')
235 device bge # Broadcom BCM570x (``Tigon III'')
236 device stge # Sundance/Tamarack TC9021 Gigabit Ethernet
237 device msk # Marvell/SysKonnect Yukon II Gigabit Ethernet
238 device nfe # NVIDIA nForce MCP 10/100/Gigabit Ethernet
241 # 'device ed' requires 'device miibus'
242 device ed0 at isa? disable port 0x280 irq 10 iomem 0xd8000
248 options IEEE80211_DEBUG #enable debugging msgs
249 options IEEE80211_SUPPORT_MESH #enable 802.11s D3.0 support
250 options IEEE80211_SUPPORT_TDMA #enable TDMA support
251 device wlan # 802.11 support
252 device wlan_ccmp # 802.11 CCMP support
253 device wlan_tkip # 802.11 TKIP support
254 device wlan_wep # 802.11 WEP support
255 #device wlan_amrr # AMRR
257 # Aironet 4500/4800 802.11 wireless NICs. Note: the declaration below will
258 # work for PCMCIA and PCI cards, as well as ISA cards set to ISA PnP
259 # mode (the factory default). If you set the switches on your ISA
260 # card for a manually chosen I/O address and IRQ, you must specify
261 # those parameters here.
263 device ral # Ralink Technology 802.11 wireless NIC
264 #device rtw # RealTek 802.11 wireless NIC
265 # WaveLAN/IEEE 802.11 wireless NICs. Note: the WaveLAN/IEEE really
266 # exists only as a PCMCIA device, so there is no ISA attachment needed
267 # and resources will always be dynamically assigned by the pccard code.
270 # The probe order of these is presently determined by i386/isa/isa_compat.c.
271 #device le0 at isa? disable port 0x300 irq 5 iomem 0xd0000
272 device lnc0 at isa? disable port 0x280 irq 10 drq 0
273 device cs0 at isa? disable port 0x300
274 device sn0 at isa? disable port 0x300 irq 10
276 # Pseudo devices - the number indicates how many units to allocate.
277 pseudo-device loop # Network loopback
278 pseudo-device ether # Ethernet support
279 pseudo-device sl 1 # Kernel SLIP
280 pseudo-device ppp 1 # Kernel PPP
281 pseudo-device tun # Packet tunnel.
282 pseudo-device pty # Pseudo-ttys (telnet etc)
283 pseudo-device md # Memory "disks"
284 pseudo-device gif # IPv6 and IPv4 tunneling
285 pseudo-device faith 1 # IPv6-to-IPv4 relaying (translation)
287 # The `bpf' pseudo-device enables the Berkeley Packet Filter.
288 # Be aware of the administrative consequences of enabling this!
289 pseudo-device bpf #Berkeley packet filter
291 pseudo-device crypto # core crypto support, used by wlan
294 device uhci # UHCI PCI->USB interface
295 device ohci # OHCI PCI->USB interface
296 device usb # USB Bus (required)
297 device ugen # Generic
298 device uhid # "Human Interface Devices"
299 device ukbd # Keyboard
300 device ulpt # Printer
301 device umass # Disks/Mass storage - Requires scbus and da
303 device uscanner # Scanners
304 device urio # Diamond Rio MP3 Player
305 # USB Ethernet, requires mii
306 device aue # ADMtek USB ethernet
307 device axe # ASIX Electronics USB Ethernet
308 device cue # CATC USB ethernet
309 device kue # Kawasaki LSI USB ethernet
310 device rue # RealTek 8150 based USB ethernet
311 # USB wireless NICs, requires wlan, wlan_amrr
312 #device rum # Ralink Technology RT2501USB/RT2601USB
313 #device ural # Ralink Technology RT2500USB
316 device firewire # FireWire bus code
317 device sbp # SCSI over FireWire (Requires scbus and da)
318 device fwe # Ethernet over FireWire (non-standard!)