2 # GENERIC -- Generic kernel configuration file for DragonFly/x86_64
4 # Check the LINT configuration file in sys/config, for an
5 # exhaustive list of options.
14 makeoptions DEBUG=-g #Build kernel with gdb(1) debug symbols
16 options INET #InterNETworking
17 options INET6 #IPv6 communications protocols
18 options HAMMER #Hammer Filesystem
19 options FFS #Berkeley Fast Filesystem
20 options FFS_ROOT #FFS usable as root device [keep this!]
21 options SOFTUPDATES #Enable FFS soft updates support
22 options UFS_DIRHASH #Improve performance on big directories
23 options MFS #Memory Filesystem
24 options MD_ROOT #MD is a potential root device
25 options NFS #Network Filesystem
26 options NFS_ROOT #NFS usable as root device, NFS required
27 options MSDOSFS #MSDOS Filesystem
28 options CD9660 #ISO 9660 Filesystem
29 options PROCFS #Process filesystem
30 options COMPAT_43 #Compatible with BSD 4.3 [KEEP THIS!]
31 options SCSI_DELAY=5000 #Delay (in ms) before probing SCSI
32 options DEVICE_POLLING # Support mixed interrupt-polling
33 # handling of network device drivers
34 options UCONSOLE #Allow users to grab the console
35 options KTRACE #ktrace(1) support
36 options SYSVSHM #SYSV-style shared memory
37 options SYSVMSG #SYSV-style message queues
38 options SYSVSEM #SYSV-style semaphores
39 options P1003_1B #Posix P1003_1B real-time extensions
40 options _KPOSIX_PRIORITY_SCHEDULING
41 options ICMP_BANDLIM #Rate limit bad replies
42 options KBD_INSTALL_CDEV # install a CDEV entry in /dev
43 options AHC_REG_PRETTY_PRINT # Print register bitfields in debug
44 # output. Adds ~128k to driver.
45 options AHD_REG_PRETTY_PRINT # Print register bitfields in debug
46 # output. Adds ~215k to driver.
48 # To make an SMP kernel both SMP and APIC_IO are usually
49 # specified. SMP boxes with severely broken BIOSes which
50 # boot fine for non-SMP builds *might* work in SMP mode
51 # if you define SMP and leave APIC_IO turned off.
53 #options SMP # Symmetric MultiProcessor Kernel
54 #options APIC_IO # Symmetric (APIC) I/O
56 # Debugging for Development
62 #options ACPI_QUIRK_VMWARE # VMware's ACPI-fast24 timer is broken
67 # AHCI driver, this will override NATA for AHCI devices,
68 # both drivers may be included.
72 # Sil3124/3132/3531 driver
76 # NEW-ATA (NATA) and ATAPI devices
79 device natadisk # ATA disk drives
80 device natapicd # ATAPI CDROM drives
81 device natapifd # ATAPI floppy drives
82 device natapist # ATAPI tape drives
83 device natapicam # Emulate ATAPI devices as SCSI
84 device nataraid # support for ATA software RAID
86 device natausb # ATA-over-USB support
87 options ATA_STATIC_ID # Static device numbering
89 # LEGACY ATA and ATAPI devices
90 #device ata0 at isa? port IO_WD1 irq 14
91 #device ata1 at isa? port IO_WD2 irq 15
93 #device atadisk # ATA disk drives
94 #device atapicd # ATAPI CDROM drives
95 #device atapifd # ATAPI floppy drives
96 #device atapist # ATAPI tape drives
97 #device atapicam # Emulate ATAPI devices as SCSI via CAM
98 #options ATA_STATIC_ID #Static device numbering
101 device ahb # EISA AHA1742 family
102 device ahc # AHA2940 and onboard AIC7xxx devices
103 device ahd # AHA39320/29320 and onboard AIC79xx devices
104 device amd # AMD 53C974 (Tekram DC-390(T))
105 device isp # Qlogic family
106 device mpt # LSI-Logic MPT/Fusion
107 device ncr # NCR/Symbios Logic
108 device sym # NCR/Symbios Logic (newer chipsets)
109 options SYM_SETUP_LP_PROBE_MAP=0x40
110 # Allow ncr to attach legacy NCR devices when
111 # both sym and ncr are configured
119 device ncv # NCR 53C500
120 device nsp # Workbit Ninja SCSI-3
121 device stg # TMC 18C30/18C50
124 device scbus # SCSI bus (required)
125 device da # Direct Access (disks)
126 device sa # Sequential Access (tape etc)
128 device pass # Passthrough device (direct SCSI access)
129 device sg # Passthrough device (linux scsi generic)
131 # RAID controllers interfaced to the SCSI subsystem
132 device asr # DPT SmartRAID V, VI and Adaptec SCSI RAID
133 device dpt # DPT Smartcache - See LINT for options!
134 device iir # Intel Integrated RAID
135 device mly # Mylex AcceleRAID/eXtremeRAID
136 device ciss # Compaq SmartRAID 5* series
139 device aac # Adaptec FSA RAID, Dell PERC2/PERC3
140 #device aacp # SCSI passthrough for aac (requires CAM)
141 device ida # Compaq Smart RAID
142 device ips # IBM ServeRAID
143 device amr # AMI MegaRAID
144 device mlx # Mylex DAC960 family
145 device twe # 3ware Escalade 7000/8000's
146 device twa # 3ware Escalade 9000's
148 # atkbdc0 controls both the keyboard and the PS/2 mouse
149 device atkbdc0 at isa? port IO_KBD
150 device atkbd0 at atkbdc? irq 1 flags 0x1
151 device psm0 at atkbdc? irq 12
155 # kbdmux is the keyboard multiplexer
158 # splash screen/screen saver
161 # syscons is the default console driver, resembling an SCO console
162 device sc0 at isa? flags 0x100
163 options SC_PIXEL_MODE # add support for the raster text mode
165 device agp # support several AGP chipsets
167 # HW monitoring devices
168 device lm0 at isa? port 0x290
169 device it0 at isa? port 0x290
170 device it1 at isa? port 0xc00
171 device it2 at isa? port 0xd00
173 # PCCARD (PCMCIA) support
179 device sio0 at isa? port IO_COM1 flags 0x10 irq 4
180 device sio1 at isa? port IO_COM2 irq 3
181 device sio2 at isa? disable port IO_COM3 irq 5
182 device sio3 at isa? disable port IO_COM4 irq 9
185 device ppc0 at isa? irq 7
186 device ppbus # Parallel port bus (required)
188 device plip # TCP/IP over parallel
189 device ppi # Parallel port interface device
190 #device vpo # Requires scbus and da
194 device de # DEC/Intel DC21x4x (``Tulip'')
195 device txp # 3Com 3cR990 (``Typhoon'')
196 device vx # 3Com 3c590, 3c595 (``Vortex'')
198 device em # Intel PRO/1000 adapter Gigabit Ethernet Card (``Wiseman'')
200 device ig_hal # Intel PRO/1000 hardware abstraction layer
202 # PCI Ethernet NICs that use the common MII bus controller code.
203 # NOTE: Be sure to keep the 'device miibus' line in order to use these NICs!
204 device miibus # MII bus support
205 device ae # Attansic/Atheros L2 Fast Ethernet
206 device age # Attansic/Atheros L1 Gigabit Ethernet
207 device ale # Atheros AR8121/AR8113/AR8114
208 device bce # Broadcom NetXtreme II Gigabit Ethernet
209 device bfe # Broadcom BCM440x 10/100 Ethernet
210 device dc # DEC/Intel 21143 and various workalikes
211 device et # Agere ET1310 10/100/1000 Ethernet
212 device fxp # Intel EtherExpress PRO/100B (82557, 82558)
213 device jme # JMicron Gigabit/Fast Ethernet
214 device pcn # AMD Am79C97x PCI 10/100 NICs
215 device rl # RealTek 8129/8139
216 device re # RealTek 8139C+/8169
217 device sf # Adaptec AIC-6915 (``Starfire'')
218 device sis # Silicon Integrated Systems SiS 900/SiS 7016
219 device sk # SysKonnect GEnesis, LinkSys EG1023, D-Link
220 device ste # Sundance ST201 (D-Link DFE-550TX)
221 device tl # Texas Instruments ThunderLAN
222 device tx # SMC EtherPower II (83c170 ``EPIC'')
223 device vge # VIA 612x GigE
224 device vr # VIA Rhine, Rhine II
225 device wb # Winbond W89C840F
226 device xl # 3Com 3c90x (``Boomerang'', ``Cyclone'')
227 device bge # Broadcom BCM570x (``Tigon III'')
228 device stge # Sundance/Tamarack TC9021 Gigabit Ethernet
229 device msk # Marvell/SysKonnect Yukon II Gigabit Ethernet
230 device nfe # NVIDIA nForce MCP 10/100/Gigabit Ethernet
233 # 'device ed' requires 'device miibus'
234 device ed0 at isa? disable port 0x280 irq 10 iomem 0xd8000
240 device wlan # 802.11 support
241 device wlan_ccmp # 802.11 CCMP support
242 device wlan_tkip # 802.11 TKIP support
243 device wlan_wep # 802.11 WEP support
244 # 802.11 TX rate control algorithms
245 #device wlan_ratectl_amrr # AMRR
246 device wlan_ratectl_onoe # Onoe
247 device wlan_ratectl_sample # Sample
249 # Aironet 4500/4800 802.11 wireless NICs. Note: the declaration below will
250 # work for PCMCIA and PCI cards, as well as ISA cards set to ISA PnP
251 # mode (the factory default). If you set the switches on your ISA
252 # card for a manually chosen I/O address and IRQ, you must specify
253 # those parameters here.
255 device ral # Ralink Technology 802.11 wireless NIC
256 # Requires wlan_ratectl_onoe and
257 # wlan_ratectl_sample
258 device rtw # RealTek 802.11 wireless NIC
259 # Requires wlan_ratectl_onoe and wlan_wep
260 # WaveLAN/IEEE 802.11 wireless NICs. Note: the WaveLAN/IEEE really
261 # exists only as a PCMCIA device, so there is no ISA attachment needed
262 # and resources will always be dynamically assigned by the pccard code.
265 # The probe order of these is presently determined by i386/isa/isa_compat.c.
266 #device le0 at isa? disable port 0x300 irq 5 iomem 0xd0000
267 device lnc0 at isa? disable port 0x280 irq 10 drq 0
268 device cs0 at isa? disable port 0x300
269 device sn0 at isa? disable port 0x300 irq 10
271 # Pseudo devices - the number indicates how many units to allocate.
272 pseudo-device loop # Network loopback
273 pseudo-device ether # Ethernet support
274 pseudo-device sl 1 # Kernel SLIP
275 pseudo-device ppp 1 # Kernel PPP
276 pseudo-device tun # Packet tunnel.
277 pseudo-device pty # Pseudo-ttys (telnet etc)
278 pseudo-device md # Memory "disks"
279 pseudo-device gif # IPv6 and IPv4 tunneling
280 pseudo-device faith 1 # IPv6-to-IPv4 relaying (translation)
282 # The `bpf' pseudo-device enables the Berkeley Packet Filter.
283 # Be aware of the administrative consequences of enabling this!
284 pseudo-device bpf #Berkeley packet filter
286 pseudo-device crypto # core crypto support, used by wlan
289 device uhci # UHCI PCI->USB interface
290 device ohci # OHCI PCI->USB interface
291 device usb # USB Bus (required)
292 device ugen # Generic
293 device uhid # "Human Interface Devices"
294 device ukbd # Keyboard
295 device ulpt # Printer
296 device umass # Disks/Mass storage - Requires scbus and da
298 device uscanner # Scanners
299 device urio # Diamond Rio MP3 Player
300 # USB Ethernet, requires mii
301 device aue # ADMtek USB ethernet
302 device axe # ASIX Electronics USB Ethernet
303 device cue # CATC USB ethernet
304 device kue # Kawasaki LSI USB ethernet
305 device rue # RealTek 8150 based USB ethernet
306 # USB wireless NICs, requires wlan, wlan_ratectl_onoe
307 device rum # Ralink Technology RT2501USB/RT2601USB
308 device ural # Ralink Technology RT2500USB
311 device firewire # FireWire bus code
312 device sbp # SCSI over FireWire (Requires scbus and da)
313 device fwe # Ethernet over FireWire (non-standard!)