2 # GENERIC -- Generic kernel configuration file for DragonFly/x86_64
4 # Check the LINT configuration file in sys/config, for an
5 # exhaustive list of options.
14 makeoptions DEBUG=-g #Build kernel with gdb(1) debug symbols
16 options INET #InterNETworking
17 options INET6 #IPv6 communications protocols
18 options HAMMER #Hammer Filesystem
19 options FFS #Berkeley Fast Filesystem
20 options FFS_ROOT #FFS usable as root device [keep this!]
21 options SOFTUPDATES #Enable FFS soft updates support
22 options UFS_DIRHASH #Improve performance on big directories
23 options MFS #Memory Filesystem
24 options MD_ROOT #MD is a potential root device
25 options NFS #Network Filesystem
26 options NFS_ROOT #NFS usable as root device, NFS required
27 options MSDOSFS #MSDOS Filesystem
28 options CD9660 #ISO 9660 Filesystem
29 options PROCFS #Process filesystem
30 options COMPAT_43 #Compatible with BSD 4.3 [KEEP THIS!]
31 options SCSI_DELAY=5000 #Delay (in ms) before probing SCSI
32 options DEVICE_POLLING # Support mixed interrupt-polling
33 # handling of network device drivers
34 options UCONSOLE #Allow users to grab the console
35 options KTRACE #ktrace(1) support
36 options SYSVSHM #SYSV-style shared memory
37 options SYSVMSG #SYSV-style message queues
38 options SYSVSEM #SYSV-style semaphores
39 options P1003_1B #Posix P1003_1B real-time extensions
40 options _KPOSIX_PRIORITY_SCHEDULING
41 options ICMP_BANDLIM #Rate limit bad replies
42 options KBD_INSTALL_CDEV # install a CDEV entry in /dev
43 options AHC_REG_PRETTY_PRINT # Print register bitfields in debug
44 # output. Adds ~128k to driver.
45 options AHD_REG_PRETTY_PRINT # Print register bitfields in debug
46 # output. Adds ~215k to driver.
48 # To make an SMP kernel both SMP and APIC_IO are usually
49 # specified. SMP boxes with severely broken BIOSes which
50 # boot fine for non-SMP builds *might* work in SMP mode
51 # if you define SMP and leave APIC_IO turned off.
53 #options SMP # Symmetric MultiProcessor Kernel
54 #options APIC_IO # Symmetric (APIC) I/O
56 # Debugging for Development
64 # AHCI driver, this will override NATA for AHCI devices,
65 # both drivers may be included.
69 # Sil3124/3132/3531 driver
73 # NEW-ATA (NATA) and ATAPI devices
76 device natadisk # ATA disk drives
77 device natapicd # ATAPI CDROM drives
78 device natapifd # ATAPI floppy drives
79 device natapist # ATAPI tape drives
80 device natapicam # Emulate ATAPI devices as SCSI
81 device nataraid # support for ATA software RAID
83 device natausb # ATA-over-USB support
84 options ATA_STATIC_ID # Static device numbering
86 # LEGACY ATA and ATAPI devices
87 #device ata0 at isa? port IO_WD1 irq 14
88 #device ata1 at isa? port IO_WD2 irq 15
90 #device atadisk # ATA disk drives
91 #device atapicd # ATAPI CDROM drives
92 #device atapifd # ATAPI floppy drives
93 #device atapist # ATAPI tape drives
94 #device atapicam # Emulate ATAPI devices as SCSI via CAM
95 #options ATA_STATIC_ID #Static device numbering
98 device ahb # EISA AHA1742 family
99 device ahc # AHA2940 and onboard AIC7xxx devices
100 device ahd # AHA39320/29320 and onboard AIC79xx devices
101 device amd # AMD 53C974 (Tekram DC-390(T))
102 device isp # Qlogic family
103 device mpt # LSI-Logic MPT/Fusion
104 device ncr # NCR/Symbios Logic
105 device sym # NCR/Symbios Logic (newer chipsets)
106 options SYM_SETUP_LP_PROBE_MAP=0x40
107 # Allow ncr to attach legacy NCR devices when
108 # both sym and ncr are configured
116 device ncv # NCR 53C500
117 device nsp # Workbit Ninja SCSI-3
118 device stg # TMC 18C30/18C50
121 device scbus # SCSI bus (required)
122 device da # Direct Access (disks)
123 device sa # Sequential Access (tape etc)
125 device pass # Passthrough device (direct SCSI access)
126 device sg # Passthrough device (linux scsi generic)
128 # RAID controllers interfaced to the SCSI subsystem
129 device asr # DPT SmartRAID V, VI and Adaptec SCSI RAID
130 device dpt # DPT Smartcache - See LINT for options!
131 device iir # Intel Integrated RAID
132 device mly # Mylex AcceleRAID/eXtremeRAID
133 device ciss # Compaq SmartRAID 5* series
136 device aac # Adaptec FSA RAID, Dell PERC2/PERC3
137 #device aacp # SCSI passthrough for aac (requires CAM)
138 device ida # Compaq Smart RAID
139 device ips # IBM ServeRAID
140 device amr # AMI MegaRAID
141 device mlx # Mylex DAC960 family
142 device twe # 3ware Escalade 7000/8000's
143 device twa # 3ware Escalade 9000's
145 # atkbdc0 controls both the keyboard and the PS/2 mouse
146 device atkbdc0 at isa? port IO_KBD
147 device atkbd0 at atkbdc? irq 1 flags 0x1
148 device psm0 at atkbdc? irq 12
152 # kbdmux is the keyboard multiplexer
155 # splash screen/screen saver
158 # syscons is the default console driver, resembling an SCO console
159 device sc0 at isa? flags 0x100
160 options SC_PIXEL_MODE # add support for the raster text mode
162 device agp # support several AGP chipsets
164 # HW monitoring devices
165 device lm0 at isa? port 0x290
166 device it0 at isa? port 0x290
167 device it1 at isa? port 0xc00
168 device it2 at isa? port 0xd00
170 # PCCARD (PCMCIA) support
176 device sio0 at isa? port IO_COM1 flags 0x10 irq 4
177 device sio1 at isa? port IO_COM2 irq 3
178 device sio2 at isa? disable port IO_COM3 irq 5
179 device sio3 at isa? disable port IO_COM4 irq 9
182 device ppc0 at isa? irq 7
183 device ppbus # Parallel port bus (required)
185 device plip # TCP/IP over parallel
186 device ppi # Parallel port interface device
187 #device vpo # Requires scbus and da
191 device de # DEC/Intel DC21x4x (``Tulip'')
192 device txp # 3Com 3cR990 (``Typhoon'')
193 device vx # 3Com 3c590, 3c595 (``Vortex'')
195 device em # Intel PRO/1000 adapter Gigabit Ethernet Card (``Wiseman'')
197 device ig_hal # Intel PRO/1000 hardware abstraction layer
199 # PCI Ethernet NICs that use the common MII bus controller code.
200 # NOTE: Be sure to keep the 'device miibus' line in order to use these NICs!
201 device miibus # MII bus support
202 device ae # Attansic/Atheros L2 Fast Ethernet
203 device age # Attansic/Atheros L1 Gigabit Ethernet
204 device ale # Atheros AR8121/AR8113/AR8114
205 device bce # Broadcom NetXtreme II Gigabit Ethernet
206 device bfe # Broadcom BCM440x 10/100 Ethernet
207 device dc # DEC/Intel 21143 and various workalikes
208 device et # Agere ET1310 10/100/1000 Ethernet
209 device fxp # Intel EtherExpress PRO/100B (82557, 82558)
210 device jme # JMicron Gigabit/Fast Ethernet
211 device pcn # AMD Am79C97x PCI 10/100 NICs
212 device rl # RealTek 8129/8139
213 device re # RealTek 8139C+/8169
214 device sf # Adaptec AIC-6915 (``Starfire'')
215 device sis # Silicon Integrated Systems SiS 900/SiS 7016
216 device sk # SysKonnect GEnesis, LinkSys EG1023, D-Link
217 device ste # Sundance ST201 (D-Link DFE-550TX)
218 device tl # Texas Instruments ThunderLAN
219 device tx # SMC EtherPower II (83c170 ``EPIC'')
220 device vge # VIA 612x GigE
221 device vr # VIA Rhine, Rhine II
222 device wb # Winbond W89C840F
223 device xl # 3Com 3c90x (``Boomerang'', ``Cyclone'')
224 device bge # Broadcom BCM570x (``Tigon III'')
225 device stge # Sundance/Tamarack TC9021 Gigabit Ethernet
226 device msk # Marvell/SysKonnect Yukon II Gigabit Ethernet
227 device nfe # NVIDIA nForce MCP 10/100/Gigabit Ethernet
230 # 'device ed' requires 'device miibus'
231 device ed0 at isa? disable port 0x280 irq 10 iomem 0xd8000
237 device wlan # 802.11 support
238 device wlan_ccmp # 802.11 CCMP support
239 device wlan_tkip # 802.11 TKIP support
240 device wlan_wep # 802.11 WEP support
241 # 802.11 TX rate control algorithms
242 #device wlan_ratectl_amrr # AMRR
243 device wlan_ratectl_onoe # Onoe
244 device wlan_ratectl_sample # Sample
246 # Aironet 4500/4800 802.11 wireless NICs. Note: the declaration below will
247 # work for PCMCIA and PCI cards, as well as ISA cards set to ISA PnP
248 # mode (the factory default). If you set the switches on your ISA
249 # card for a manually chosen I/O address and IRQ, you must specify
250 # those parameters here.
252 device ral # Ralink Technology 802.11 wireless NIC
253 # Requires wlan_ratectl_onoe and
254 # wlan_ratectl_sample
255 device rtw # RealTek 802.11 wireless NIC
256 # Requires wlan_ratectl_onoe and wlan_wep
257 # WaveLAN/IEEE 802.11 wireless NICs. Note: the WaveLAN/IEEE really
258 # exists only as a PCMCIA device, so there is no ISA attachment needed
259 # and resources will always be dynamically assigned by the pccard code.
262 # The probe order of these is presently determined by i386/isa/isa_compat.c.
263 #device le0 at isa? disable port 0x300 irq 5 iomem 0xd0000
264 device lnc0 at isa? disable port 0x280 irq 10 drq 0
265 device cs0 at isa? disable port 0x300
266 device sn0 at isa? disable port 0x300 irq 10
268 # Pseudo devices - the number indicates how many units to allocate.
269 pseudo-device loop # Network loopback
270 pseudo-device ether # Ethernet support
271 pseudo-device sl 1 # Kernel SLIP
272 pseudo-device ppp 1 # Kernel PPP
273 pseudo-device tun # Packet tunnel.
274 pseudo-device pty # Pseudo-ttys (telnet etc)
275 pseudo-device md # Memory "disks"
276 pseudo-device gif # IPv6 and IPv4 tunneling
277 pseudo-device faith 1 # IPv6-to-IPv4 relaying (translation)
279 # The `bpf' pseudo-device enables the Berkeley Packet Filter.
280 # Be aware of the administrative consequences of enabling this!
281 pseudo-device bpf #Berkeley packet filter
283 pseudo-device crypto # core crypto support, used by wlan
286 device uhci # UHCI PCI->USB interface
287 device ohci # OHCI PCI->USB interface
288 device usb # USB Bus (required)
289 device ugen # Generic
290 device uhid # "Human Interface Devices"
291 device ukbd # Keyboard
292 device ulpt # Printer
293 device umass # Disks/Mass storage - Requires scbus and da
295 device uscanner # Scanners
296 device urio # Diamond Rio MP3 Player
297 # USB Ethernet, requires mii
298 device aue # ADMtek USB ethernet
299 device axe # ASIX Electronics USB Ethernet
300 device cue # CATC USB ethernet
301 device kue # Kawasaki LSI USB ethernet
302 device rue # RealTek 8150 based USB ethernet
303 # USB wireless NICs, requires wlan, wlan_ratectl_onoe
304 device rum # Ralink Technology RT2501USB/RT2601USB
305 device ural # Ralink Technology RT2500USB
308 device firewire # FireWire bus code
309 device sbp # SCSI over FireWire (Requires scbus and da)
310 device fwe # Ethernet over FireWire (non-standard!)