2 # GENERIC -- Generic kernel configuration file for DragonFly/i386
4 # Check the LINT configuration file in sys/config, for an
5 # exhaustive list of options.
7 # $DragonFly: src/sys/config/GENERIC,v 1.42 2006/11/07 06:43:22 dillon Exp $
18 makeoptions DEBUG=-g #Build kernel with gdb(1) debug symbols
20 options MATH_EMULATE #Support for x87 emulation
21 options INET #InterNETworking
22 options INET6 #IPv6 communications protocols
23 options FFS #Berkeley Fast Filesystem
24 options FFS_ROOT #FFS usable as root device [keep this!]
25 options SOFTUPDATES #Enable FFS soft updates support
26 options UFS_DIRHASH #Improve performance on big directories
27 options MFS #Memory Filesystem
28 options MD_ROOT #MD is a potential root device
29 options NFS #Network Filesystem
30 options NFS_ROOT #NFS usable as root device, NFS required
31 options MSDOSFS #MSDOS Filesystem
32 options CD9660 #ISO 9660 Filesystem
33 options PROCFS #Process filesystem
34 options COMPAT_43 #Compatible with BSD 4.3 [KEEP THIS!]
35 options COMPAT_DF12 #Compatible with DragonFly 1.2 and earlier
36 options SCSI_DELAY=5000 #Delay (in ms) before probing SCSI
37 options DEVICE_POLLING # Support mixed interrupt-polling
38 # handling of network device drivers
39 options UCONSOLE #Allow users to grab the console
40 options USERCONFIG #boot -c editor
41 options VISUAL_USERCONFIG #visual boot -c editor
42 options KTRACE #ktrace(1) support
43 options SYSVSHM #SYSV-style shared memory
44 options SYSVMSG #SYSV-style message queues
45 options SYSVSEM #SYSV-style semaphores
46 options P1003_1B #Posix P1003_1B real-time extensions
47 options _KPOSIX_PRIORITY_SCHEDULING
48 options ICMP_BANDLIM #Rate limit bad replies
49 options KBD_INSTALL_CDEV # install a CDEV entry in /dev
50 options AHC_REG_PRETTY_PRINT # Print register bitfields in debug
51 # output. Adds ~128k to driver.
52 options AHD_REG_PRETTY_PRINT # Print register bitfields in debug
53 # output. Adds ~215k to driver.
55 # To make an SMP kernel both SMP and APIC_IO are usually
56 # specified. SMP boxes with severely broken BIOSes which
57 # boot fine for non-SMP builds *might* work in SMP mode
58 # if you define SMP and leave APIC_IO turned off.
60 #options SMP # Symmetric MultiProcessor Kernel
61 #options APIC_IO # Symmetric (APIC) I/O
63 # Debugging for Development
75 device fdc0 at isa? port IO_FD1 irq 6 drq 2
76 device fd0 at fdc0 drive 0
77 device fd1 at fdc0 drive 1
79 # If you have a Toshiba Libretto with its Y-E Data PCMCIA floppy,
80 # don't use the above line for fdc0 but the following one:
83 # ATA and ATAPI devices
84 device ata0 at isa? port IO_WD1 irq 14
85 device ata1 at isa? port IO_WD2 irq 15
87 device atadisk # ATA disk drives
88 device atapicd # ATAPI CDROM drives
89 device atapifd # ATAPI floppy drives
90 device atapist # ATAPI tape drives
91 device atapicam # Emulate ATAPI devices as SCSI via CAM
92 options ATA_STATIC_ID #Static device numbering
95 device ahb # EISA AHA1742 family
96 device ahc # AHA2940 and onboard AIC7xxx devices
97 device ahd # AHA39320/29320 and onboard AIC79xx devices
98 device amd # AMD 53C974 (Tekram DC-390(T))
99 device isp # Qlogic family
100 device mpt # LSI-Logic MPT/Fusion
101 device ncr # NCR/Symbios Logic
102 device sym # NCR/Symbios Logic (newer chipsets)
103 options SYM_SETUP_LP_PROBE_MAP=0x40
104 # Allow ncr to attach legacy NCR devices when
105 # both sym and ncr are configured
113 device ncv # NCR 53C500
114 device nsp # Workbit Ninja SCSI-3
115 device stg # TMC 18C30/18C50
118 device scbus # SCSI bus (required)
119 device da # Direct Access (disks)
120 device sa # Sequential Access (tape etc)
122 device pass # Passthrough device (direct SCSI access)
124 # RAID controllers interfaced to the SCSI subsystem
125 device asr # DPT SmartRAID V, VI and Adaptec SCSI RAID
126 device dpt # DPT Smartcache - See LINT for options!
127 device iir # Intel Integrated RAID
128 device mly # Mylex AcceleRAID/eXtremeRAID
129 device ciss # Compaq SmartRAID 5* series
132 device aac # Adaptec FSA RAID, Dell PERC2/PERC3
133 #device aacp # SCSI passthrough for aac (requires CAM)
134 device ida # Compaq Smart RAID
135 device ips # IBM ServeRAID
136 device amr # AMI MegaRAID
137 device mlx # Mylex DAC960 family
138 device twe # 3ware Escalade 7000/8000's
139 device twa # 3ware Escalade 9000's
140 device pst # Promise Supertrack
142 # atkbdc0 controls both the keyboard and the PS/2 mouse
143 device atkbdc0 at isa? port IO_KBD
144 device atkbd0 at atkbdc? irq 1 flags 0x1
145 device psm0 at atkbdc? irq 12
149 # splash screen/screen saver
152 # syscons is the default console driver, resembling an SCO console
153 device sc0 at isa? flags 0x100
154 options SC_PIXEL_MODE # add support for the raster text mode
156 device agp # support several AGP chipsets
158 # Floating point support - do not disable.
159 device npx0 at nexus? port IO_NPX irq 13
161 # Power management support (see LINT for more options)
162 device apm0 at nexus? disable flags 0x20 # Advanced Power Management
164 # PCCARD (PCMCIA) support
170 device sio0 at isa? port IO_COM1 flags 0x10 irq 4
171 device sio1 at isa? port IO_COM2 irq 3
172 device sio2 at isa? disable port IO_COM3 irq 5
173 device sio3 at isa? disable port IO_COM4 irq 9
176 device ppc0 at isa? irq 7
177 device ppbus # Parallel port bus (required)
179 device plip # TCP/IP over parallel
180 device ppi # Parallel port interface device
181 #device vpo # Requires scbus and da
185 device de # DEC/Intel DC21x4x (``Tulip'')
186 device em # Intel PRO/1000 adapter Gigabit Ethernet Card (``Wiseman'')
187 device txp # 3Com 3cR990 (``Typhoon'')
188 device vx # 3Com 3c590, 3c595 (``Vortex'')
190 # PCI Ethernet NICs that use the common MII bus controller code.
191 # NOTE: Be sure to keep the 'device miibus' line in order to use these NICs!
192 device miibus # MII bus support
193 device bfe # Broadcom BCM440x 10/100 Ethernet
194 device dc # DEC/Intel 21143 and various workalikes
195 device fxp # Intel EtherExpress PRO/100B (82557, 82558)
196 device pcn # AMD Am79C97x PCI 10/100 NICs
197 device rl # RealTek 8129/8139
198 device re # RealTek 8139C+/8169
199 device sf # Adaptec AIC-6915 (``Starfire'')
200 device sis # Silicon Integrated Systems SiS 900/SiS 7016
201 device sk # SysKonnect GEnesis, LinkSys EG1023, D-Link
202 device ste # Sundance ST201 (D-Link DFE-550TX)
203 device tl # Texas Instruments ThunderLAN
204 device tx # SMC EtherPower II (83c170 ``EPIC'')
205 device vge # VIA 612x GigE
206 device vr # VIA Rhine, Rhine II
207 device wb # Winbond W89C840F
208 device xl # 3Com 3c90x (``Boomerang'', ``Cyclone'')
209 device bge # Broadcom BCM570x (``Tigon III'')
212 # 'device ed' requires 'device miibus'
213 device ed0 at isa? disable port 0x280 irq 10 iomem 0xd8000
216 device fe0 at isa? disable port 0x300
221 device wlan # 802.11 support
222 device wlan_ccmp # 802.11 CCMP support
223 device wlan_tkip # 802.11 TKIP support
224 device wlan_wep # 802.11 WEP support
225 #device wlan_ratectl_onoe # 802.11 Onoe TX rate control algorithm
227 # Aironet 4500/4800 802.11 wireless NICs. Note: the declaration below will
228 # work for PCMCIA and PCI cards, as well as ISA cards set to ISA PnP
229 # mode (the factory default). If you set the switches on your ISA
230 # card for a manually chosen I/O address and IRQ, you must specify
231 # those parameters here.
233 #device awi # PRISM I IEEE 802.11b wireless NIC
234 device ral # Ralink Technology 802.11 wireless NIC
235 #device rtw # RealTek 802.11 wireless NIC
236 # Requires wlan_ratectl_onoe
237 # WaveLAN/IEEE 802.11 wireless NICs. Note: the WaveLAN/IEEE really
238 # exists only as a PCMCIA device, so there is no ISA attachment needed
239 # and resources will always be dynamically assigned by the pccard code.
242 # The probe order of these is presently determined by i386/isa/isa_compat.c.
243 device ie0 at isa? disable port 0x300 irq 10 iomem 0xd0000
244 #device le0 at isa? disable port 0x300 irq 5 iomem 0xd0000
245 device lnc0 at isa? disable port 0x280 irq 10 drq 0
246 device cs0 at isa? disable port 0x300
247 device sn0 at isa? disable port 0x300 irq 10
249 # Pseudo devices - the number indicates how many units to allocate.
250 pseudo-device loop # Network loopback
251 pseudo-device ether # Ethernet support
252 pseudo-device sl 1 # Kernel SLIP
253 pseudo-device ppp 1 # Kernel PPP
254 pseudo-device tun # Packet tunnel.
255 pseudo-device pty # Pseudo-ttys (telnet etc)
256 pseudo-device md # Memory "disks"
257 pseudo-device gif # IPv6 and IPv4 tunneling
258 pseudo-device faith 1 # IPv6-to-IPv4 relaying (translation)
260 # The `bpf' pseudo-device enables the Berkeley Packet Filter.
261 # Be aware of the administrative consequences of enabling this!
262 pseudo-device bpf #Berkeley packet filter
264 pseudo-device crypto # core crypto support, used by wlan
267 device uhci # UHCI PCI->USB interface
268 device ohci # OHCI PCI->USB interface
269 device usb # USB Bus (required)
270 device ugen # Generic
271 device uhid # "Human Interface Devices"
272 device ukbd # Keyboard
273 device ulpt # Printer
274 device umass # Disks/Mass storage - Requires scbus and da
276 device uscanner # Scanners
277 device urio # Diamond Rio MP3 Player
278 # USB Ethernet, requires mii
279 device aue # ADMtek USB ethernet
280 device axe # ASIX Electronics USB Ethernet
281 device cue # CATC USB ethernet
282 device kue # Kawasaki LSI USB ethernet
283 device rue # RealTek 8150 based USB ethernet
286 device firewire # FireWire bus code
287 device sbp # SCSI over FireWire (Requires scbus and da)
288 device fwe # Ethernet over FireWire (non-standard!)