/* sound_config.h * * A driver for Soundcards, misc configuration parameters. * * Copyright by Hannu Savolainen 1995 * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions * are met: * 1. Redistributions of source code must retain the above copyright * notice, this list of conditions and the following disclaimer. * 2. Redistributions in binary form must reproduce the above copyright * notice, this list of conditions and the following disclaimer in the * documentation and/or other materials provided with the distribution. * * THIS SOFTWARE IS PROVIDED BY THE AUTHOR AND CONTRIBUTORS ``AS IS'' AND * ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE * IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE * ARE DISCLAIMED. IN NO EVENT SHALL THE AUTHOR OR CONTRIBUTORS BE LIABLE * FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL * DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS * OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) * HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT * LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY * OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF * SUCH DAMAGE. * * $FreeBSD: src/sys/i386/isa/sound/sound_config.h,v 1.20 1999/12/27 04:37:19 tanimura Exp $ * $DragonFly: src/sys/dev/sound/isa/i386/Attic/sound_config.h,v 1.3 2003/08/07 21:17:12 dillon Exp $ * */ /* * many variables should be reduced to a range. Here define a macro */ #define RANGE(var, low, high) (var) = \ ((var)<(low)?(low) : (var)>(high)?(high) : (var)) #undef CONFIGURE_SOUNDCARD #undef DYNAMIC_BUFFER #include #define CONFIGURE_SOUNDCARD #define DYNAMIC_BUFFER #undef LOADABLE_SOUNDCARD #include #include "soundvers.h" #if defined(ISC) || defined(SCO) || defined(SVR42) #define GENERIC_SYSV #endif #ifndef SND_DEFAULT_ENABLE #define SND_DEFAULT_ENABLE 1 #endif #ifdef CONFIGURE_SOUNDCARD #ifndef MAX_REALTIME_FACTOR #define MAX_REALTIME_FACTOR 4 #endif /************* PCM DMA buffer sizes *******************/ /* If you are using high playback or recording speeds, the default buffersize is too small. DSP_BUFFSIZE must be 64k or less. A rule of thumb is 64k for PAS16, 32k for PAS+, 16k for SB Pro and 4k for SB. If you change the DSP_BUFFSIZE, don't modify this file. Use the make config command instead. Seems to allow only 4K, 16K, 32K, 64K. */ #ifndef DSP_BUFFSIZE #define DSP_BUFFSIZE (32760) #endif #ifndef DSP_BUFFCOUNT #define DSP_BUFFCOUNT 1 /* 1 is recommended. */ #endif #define DMA_AUTOINIT 0x10 /* XXX never used */ #ifdef PC98 #define FM_MONO 0x28d2 #else #define FM_MONO 0x388 /* This is the I/O address used by AdLib */ #endif #ifndef AWE32_BASE #define AWE32_BASE 0x620 /* Default = 0x620-3, 0xA20-3, 0xE20-3 */ #endif #ifndef PAS_BASE #define PAS_BASE 0x388 #endif #ifdef JAZZ16 #ifndef JAZZ_DMA16 #define JAZZ_DMA16 5 #endif #endif /* SEQ_MAX_QUEUE is the maximum number of sequencer events buffered by the driver. (There is no need to alter this) */ #define SEQ_MAX_QUEUE 1024 #define SBFM_MAXINSTR (256) /* Size of the FM Instrument bank */ /* 128 instruments for general MIDI setup and 16 unassigned */ /* * Minor numbers for the sound driver. * * Unfortunately Creative called the codec chip of SB as a DSP. For this * reason the /dev/dsp is reserved for digitized audio use. There is a * device for true DSP processors but it will be called something else. * In v3.0 it's /dev/sndproc but this could be a temporary solution. */ #define SND_NDEVS 256 /* Number of supported devices */ #define SND_DEV_CTL 0 /* Control port /dev/mixer */ #define SND_DEV_SEQ 1 /* Sequencer output /dev/sequencer (FM synthesizer and MIDI output) */ #define SND_DEV_MIDIN 2 /* Raw midi access */ #define SND_DEV_DSP 3 /* Digitized voice /dev/dsp */ #define SND_DEV_AUDIO 4 /* Sparc compatible /dev/audio */ #define SND_DEV_DSP16 5 /* Like /dev/dsp but 16 bits/sample */ #define SND_DEV_STATUS 6 /* /dev/sndstat */ /* #7 not in use now. Was in 2.4. Free for use after v3.0. */ #define SND_DEV_SEQ2 8 /* /dev/sequencer, level 2 interface */ #define SND_DEV_SNDPROC 9 /* /dev/sndproc for programmable devices */ #define SND_DEV_PSS SND_DEV_SNDPROC #define DSP_DEFAULT_SPEED 8000 #define ON 1 #define OFF 0 #define MAX_AUDIO_DEV 5 #define MAX_MIXER_DEV 5 #define MAX_SYNTH_DEV 3 #define MAX_MIDI_DEV 6 #define MAX_TIMER_DEV 3 struct fileinfo { int mode; /* Open mode */ int flags; int dummy; /* Reference to file-flags. OS-dependent. */ }; struct address_info { int io_base; int irq; int dma; int dma2; int always_detect; /* 1=Trust me, it's there */ char *name; sound_os_info *osp; /* OS specific info */ int card_subtype; /* Driver specific. Usually 0 */ }; #define SYNTH_MAX_VOICES 32 struct voice_alloc_info { int max_voice; int used_voices; int ptr; /* For device specific use */ unsigned short map[SYNTH_MAX_VOICES]; /* (ch << 8) | (note+1) */ int timestamp; int alloc_times[SYNTH_MAX_VOICES]; }; struct channel_info { int pgm_num; int bender_value; unsigned char controllers[128]; }; /* * Process wakeup reasons */ #define WK_NONE 0x00 #define WK_WAKEUP 0x01 #define WK_TIMEOUT 0x02 #define WK_SIGNAL 0x04 #define WK_SLEEP 0x08 #define OPEN_READ PCM_ENABLE_INPUT #define OPEN_WRITE PCM_ENABLE_OUTPUT #define OPEN_READWRITE (OPEN_READ|OPEN_WRITE) #include "sound_calls.h" #include "dev_table.h" #ifndef DEB #define DEB(x) #endif #ifndef DDB /* #define DDB(x) x XXX */ #define DDB(x) #endif #define TIMER_ARMED 121234 #define TIMER_NOT_ARMED 1 #endif